Twistnfix MAGNFIX magnetic license plate holder including approval

Same content, same power, new packaging

• Suitable for aluminum and 3D license plates!
• Super strong hold: one set of MagNFix achieves a holding force of over 64 kg, more than other magnets!
• No scratches in the paint due to the gentle Velcro over the magnet
• Super slim license plate holder: only 3mm thick!
• One set = holder for one license plate

Mounting instructions

Please be sure to follow the enclosed safety instructions!
Gluing the magnets onto the license plate:
When sticking the magnets on the license plate, please make sure that the magnets
not in the embossing (aluminium license plates) or on the rivets (3D license plates)
The magnet must be glued to a flat surface, otherwise
the full adhesive force cannot be achieved.

MagNFix fastening step by step:

1. Position magnets on the bumper inside and outside and
   Test positioning. Pay attention to the mutual attraction of the
   Watch out for magnets!
2. Mark the position of the outer magnets on the license plate and
   Thoroughly clean/degrease the affected areas with an alcohol swab.
3. Remove the protective film from the magnets and stick it on the license plate.
   Press magnets firmly onto the license plate.
4. Glue the license plate fleece onto the license plate, preferably on the
   Start at the top of the license plate. Place the license plate fleece on top first.
   stick, then peel off completely and smooth downwards
   glue it in place. (An air cushion around the magnets is intentional and normal here.)
5. Mark the position of the inner magnets on the bumper and
   Thoroughly clean/degrease the affected areas with an alcohol swab.
6. Remove the protective film from the magnets and stick it on the bumper.
   Press magnets firmly onto the bumper.
7. Glue the foil cut-outs onto the magnets. To do this, glue the foil onto the magnet
   and then smooth it down from top to bottom. Here, too, a
   Air inclusion around the magnet is normal. The magnets are held by the foil
   protected from water and dirt.

• Lieferumfang: 10 magnets for the license plate, 10 magnets for the bumper, 1 Velcro strip measuring 520 x 100 mm, can be cut to fit the license plate length, 2 alcohol swabs for degreasing, matching foil pieces for covering the magnets behind the bumper, safety and application instructions, assembly and fastening instructions, approval